Product name： ABS-like Resin (engineering like resin)
Model number： Gk E series
Applicable industrial： Toys, carton figures, education, dental， jewellery， industrial modelling etc.Product advantage
Non-brittle
Anti-scratch, great weathering
Super strong with tenacity
Suitable for different post-processing like drilling, tapping, assembling etc.
Non-VOC, RoHS, Reach, En71-3 certificated
Compatible with most 3D printers
Technical specification
Flexural modulus：979.24 Mpa ±10%
Elongation at break：35.44% ±10%
Flexural strength ：44.15 MPa ±10%
Hardness(Shore D)：80-88 D
Tensile strength：38.36MPa ±10%
Density：1.05—1.25 g/cm3
Tensile modulus：447.12MPa±10% Mpa
Notched impact strength: 454.37j/m ±10%
maximum pulling strength: 1595N ±10%Viscosity：350-650 MPa·s
Yield point elongation: 7.22%±10%
Post-curing： test strip in water for 1 min post-curing with 200mw/cm²405nm.
Printing parameter
GK series are perfect on most brand LCD printers and fast printing on DLPs.
For LCD printer with RGB screen:
e.g. elegoo mars or photo s base 50s, each layer 8s, layer height 50 micron.
For LCD printer with monochrome screen:
e.g. satori base 50s, each layer 3s, layer height 50 micron.
For DLP printer with projector:
Bottom 15s and each layer 1-5s.
e.g. hunter base 15s, each layer 4s, layer height 50 micron.
The exposure time should be adjusted according to printer light energy, layer height and
model structure.
Cleaning and post-curing
Step 1, Spray with Isopropanol, then blow resin away with cool wind.
Step 2, Prepare two containers with Isopropanol (alcohol> 95%), and place the jobs into the
first container and slightly shake it, then soak in the second container for about 1 minute
(dental resin should not exceed 30 seconds).
Step3, Flush with water before dry it, do make it sure it ‘s 100% dried as residuary alcohol
may cause white spot or crack on jobs.
Post-curing
1. The curing time is proportional to the volume of the workpiece and inversely proportional
to the optical power of the curing chamber. Example: 100-watt LED curing box, jewellery jobs
is recommended to be cured with soaking in water for 20-30 minutes.
2. The post-cure time of dental casting resin, dental non-casting resin, and jewellery mould resin
shall not more than 5 minutes.
3. Work-pieces should be in the water during post-curing to prevent deformation, especially
for dental and jewellery.
4. Don’t forget to use cool air to dry it after post-curing.
Warning
1. This material should not be in contact with eyes, skin or clothing and should not be tasted or eaten.
