I have had an Anycubic Photon mono X printer bought from here for about a month now, and since the beginning, I have had problems with prints. I have tried to set up level a few times now and still have issues with prints not being even 50% correctly done. Also, since the beginning, I have added the magnetic plate for easy print removal, and it also seems to have issues as it often comes off of the magnet connection in some areas. Problems with prints are that most of the time, print does not "stay" on the supports and often at some point (not at the same one in the case of printing a few items, even if I print copies of the same item) layers start to not stick to one another and even some morphing happens. Does anyone have any idea what might be the case?
I have had an Anycubic Photon mono X printer bought from here for about a month now, and since the beginning, I have had problems with prints. I have tried to set up level a few times now and still have issues with prints not being even 50% correctly done. Also, since the beginning, I have added the magnetic plate for easy print removal, and it also seems to have issues as it often comes off of the magnet connection in some areas. Problems with prints are that most of the time, print does not "stay" on the supports and often at some point (not at the same one in the case of printing a few items, even if I print copies of the same item) layers start to not stick to one another and even some morphing happens. Does anyone have any idea what might be the case?